| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Suspension | Section: Rear Suspension | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000003F5Y000X |
| Title: REAR SUSPENSION: REAR SHOCK ABSORBER: INSTALLATION (2008 Sequoia) | ||
INSTALLATION
1. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
(a) Temporarily install the upper side of the shock absorber to the chassis frame with the bolt and nut.
(b) Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt.
|
(c) Connect the AVS connector (w/ AVS). |
2. INSTALL REAR STABILIZER BAR
3. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
4. INSTALL PROPELLER SHAFT ASSEMBLY (for 2WD)
5. INSTALL PROPELLER SHAFT ASSEMBLY (for 4WD)
6. INSTALL TRANSFER HEAT INSULATOR (for 4WD)
7. INSTALL PROPELLER SHAFT HEAT INSULATOR (for 4WD)
8. INSTALL TAIL EXHAUST PIPE ASSEMBLY (for 3UR-FE)
9. INSTALL TAIL EXHAUST PIPE ASSEMBLY (for 2UZ-FE)
10. INSTALL REAR WHEEL
- for Aluminum Wheel
Torque: 131 N·m (1336 kgf·cm, 97 ft·lbf)
- for Steel Wheel
Torque: 209 N·m (2131 kgf·cm, 154 ft·lbf)
11. STABILIZE SUSPENSION
(a) Lower the vehicle.
(b) Press down on the vehicle several times to stabilize the suspension.
12. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
(a) Tighten the 2 bolts and nut.
- for bolt and nut A
Torque: 135 N·m (1377 kgf·cm, 100 ft·lbf)
- for bolt B
Torque: 90 N·m (918 kgf·cm, 67 ft·lbf)
13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
|
|